grievousangel
Active member
Anyone home?
The ACA output transformers are strapped 1:3 so there is no unused winding. I would use an IC -6dB receiver at the final output.What is better for a monitor output?
1. 2503's extra secondary winding feeding a 10K attenuator? (In addition to the main mix outputs) or
2. Another set of 2503's tapped off of the same ACA booster output (which feed a 10K attenuator?)
3. Another booster circuit (could even be transformerless? feeding a 10K pot, Tapped off the output of the first stage or even second stage)
You can use an INA137 as a -6dB receiver, some sort of 10k-ish level control to DRV134s. Balanced in, balanced out +28dBu of headroom.Oh right. I was thinking 312 land, where it's 1:2.
Thanks Jeff. Does anyone have an appropriate schematic for this? I'm assuming some kind of THAT chip, ultra "transparent." Are transformers afterward necessary if you consider I'd be switching between balanced and unbalanced speaker amps?
They are just over 14" not including the XLR connectors.Hi Jeff!
What is the depth measurement of the finished SumBus32? Is it anywhere around 18 inches, or less than that?
(I've got a homemade rack in a very tightly packed little project studio, and I spec'd the construction off of other summing equipment - I'm now reconsidering that... )
BTW - I just finished up my third kit, the second of two BT50's and I have to say I'm blown away.
Enter your email address to join: