nohatnoswim
Active member
- Joined
- Aug 4, 2010
- Messages
- 36
Just moved place and did a rewire.
Power is 3 phase, star system from 1 single socket.
Implemented significant normalization on patchbays for first time
All my balanced gear is whisper quiet.
Same gear & signal paths pre move were all solid.
Problem:
16 outputs of synths going into a Vintage Balancing Rack and then into SSL interface.
Outputs are all humming at various levels ( some of the synths aren't even powered on).
Bypassing normalisation with patch cables doesn't seem to change anything on the few channels it was tested on
Visual of typical path for the Juno 6 as an example in attached diagrams.
No specific dedicated grounding scheme in place - cables into patchbays, and out - grounding on patchbays is only within the plugs and the gear.
Is this
a) The normalisation,
b) The wiring path independent of the normalisation
c) Both
d) Other
Thanks,
NHNS
Power is 3 phase, star system from 1 single socket.
Implemented significant normalization on patchbays for first time
All my balanced gear is whisper quiet.
Same gear & signal paths pre move were all solid.
Problem:
16 outputs of synths going into a Vintage Balancing Rack and then into SSL interface.
Outputs are all humming at various levels ( some of the synths aren't even powered on).
Bypassing normalisation with patch cables doesn't seem to change anything on the few channels it was tested on
Visual of typical path for the Juno 6 as an example in attached diagrams.
No specific dedicated grounding scheme in place - cables into patchbays, and out - grounding on patchbays is only within the plugs and the gear.
Is this
a) The normalisation,
b) The wiring path independent of the normalisation
c) Both
d) Other
Thanks,
NHNS