mrbutterskin
Member
- Joined
- Jun 4, 2012
- Messages
- 20
Hi Everyone,
Due to an error ordering with Omeg I'm stuck with 100 pots that I don't really have any use for.
Here are the Omeg specs:
PC2G16BU
100KB-front-nearest spindle x 100KC (Note that a B taper with Omeg is Log!)
Bush CG
Spindle M22 L=15mm
These can be used as pan pots without an indent, and I think some EQ circuits might use these as well.
They cost me 2.89GBP each, I will sell them here $2.50 apiece.
Paypal preferred, but you could send me a check as well I guess.
For shipping, I can probably fit 10 or so in a small bubble mailer - which would be around $3 to ship in the US.
More than 10, I would put in a small box and I believe that would start around $5-6 through USPS.
I have a limited number (around 30 I think) spline adapters as well that can convert the small flatted shaft to a 6mm splined one. 50¢ each.
Feel free to PM or email me at r o b i n m w (@t) g.m.a.i.l.c.o.m.
Attached is a picture.
Due to an error ordering with Omeg I'm stuck with 100 pots that I don't really have any use for.
Here are the Omeg specs:
PC2G16BU
100KB-front-nearest spindle x 100KC (Note that a B taper with Omeg is Log!)
Bush CG
Spindle M22 L=15mm
These can be used as pan pots without an indent, and I think some EQ circuits might use these as well.
They cost me 2.89GBP each, I will sell them here $2.50 apiece.
Paypal preferred, but you could send me a check as well I guess.
For shipping, I can probably fit 10 or so in a small bubble mailer - which would be around $3 to ship in the US.
More than 10, I would put in a small box and I believe that would start around $5-6 through USPS.
I have a limited number (around 30 I think) spline adapters as well that can convert the small flatted shaft to a 6mm splined one. 50¢ each.
Feel free to PM or email me at r o b i n m w (@t) g.m.a.i.l.c.o.m.
Attached is a picture.
