BrickByBrick
Member
Hey y’all. Just finished up a 251 build. Capsule is a Beesneez CK12, circuit is a micparts V251 and transformer is an AMI T14.
I bought the body from Studio939 and there’s no cutout on the body for a pad, neither is there a pcb for it.
From my basic electronics knowledge is looks like the pad is a capacitor that is tied to ground right after the capsule. I’m curious if it would be possible to add the pad switch on the power supply and use one of the unused pins on the 7 pin xlr cable. Will this work? Is there a better idea?
I bought the body from Studio939 and there’s no cutout on the body for a pad, neither is there a pcb for it.
From my basic electronics knowledge is looks like the pad is a capacitor that is tied to ground right after the capsule. I’m curious if it would be possible to add the pad switch on the power supply and use one of the unused pins on the 7 pin xlr cable. Will this work? Is there a better idea?