MartyMart
Well-known member
Fitted and tested voltages @ the TL074 all OK, when bypassed passes signal
but engaged the VU meter pegs and all output is lost !
I'm sure that I understand the very clear instructions but perhaps I've done
something stupid.
The only broken and re-made connection is the lifted 47k, all others are additional
connections to what's there already.... right ?
My 12v/-12v/0v are not taken directly from the 10 pole connection, but at the first
available "node" and these voltages test fine in circuit.
Point "C" is taken at the top of the diode which connects directly to pin 10 of the edge
connection - so that's also the correct "node"
What have I done wrong ? ... Keith !
Ta,
Marty.
but engaged the VU meter pegs and all output is lost !
I'm sure that I understand the very clear instructions but perhaps I've done
something stupid.
The only broken and re-made connection is the lifted 47k, all others are additional
connections to what's there already.... right ?
My 12v/-12v/0v are not taken directly from the 10 pole connection, but at the first
available "node" and these voltages test fine in circuit.
Point "C" is taken at the top of the diode which connects directly to pin 10 of the edge
connection - so that's also the correct "node"
What have I done wrong ? ... Keith !
Ta,
Marty.