Hi folks
A couple of questions on connections on the calreq PCB (I have the Rev 5 boards from Gustav).
there are pin out connections (seven lots) that (I presume) link the two boards and also go to power supply and inputs and outputs
could someone clear up for me just which link to which (or where).
:?
They are;
- two marked '(out)'; bottom right PCB(1) and left PCB(2) (silk side)
- two rows of six pins (one) marked '0 + - a b 0'; off centre right PCB(1) and left PCB(2)
- and three other rows (of three pins), one on PCB(1) and two on PCB(2); bottom left of both boards
If these do go to the balanced input and output and PSU do I link the boards or just run wire from each board to the right destination separately?
hope this ain't too dumb a query - my soldering's great but my schematic reading ability still leaves a bit to be desired
I looked at some of the pics of finished units but can't quite make it out
They all look really great btw :shock: - I'm WELL impressed :thumb: - just hope I can do half as good a job as some of them
If the answer's on another thread please could someone point me there
Thanks a lot
Al