sonicwarrior
Well-known member
[quote author="thedug"]
The schematic from the pdf at gyraf has some(most) of the tanlums in a different direction. The component diagram is the same as the board, but the schematic has the polarity oppositie. Should I follow the board or the schematic. What should I do if the cap isnt' labeled? Should they all be backwards?[/quote]
I hope my re-draw is correct, but I used the stuff from the Gyraf page. Would be bad if the documentation has such errors in it.
http://www.groupdiy.com/index.php?topic=18257
[quote author="thedug"]Also, there is a 100uF cap in series with a 100nF film cap near the 47uF electrolytic. The baord says 22uF but the parts list and pdf have 100uF. Will there be any problems with using the 100uF?[/quote]
Hmm, I used 100 uF in my re-design. But electronically I'm an absolute greenhorn, so I don't know if that's correct.
The schematic from the pdf at gyraf has some(most) of the tanlums in a different direction. The component diagram is the same as the board, but the schematic has the polarity oppositie. Should I follow the board or the schematic. What should I do if the cap isnt' labeled? Should they all be backwards?[/quote]
I hope my re-draw is correct, but I used the stuff from the Gyraf page. Would be bad if the documentation has such errors in it.
http://www.groupdiy.com/index.php?topic=18257
[quote author="thedug"]Also, there is a 100uF cap in series with a 100nF film cap near the 47uF electrolytic. The baord says 22uF but the parts list and pdf have 100uF. Will there be any problems with using the 100uF?[/quote]
Hmm, I used 100 uF in my re-design. But electronically I'm an absolute greenhorn, so I don't know if that's correct.