rubyscube
Member
Hello!
I'm trying to restore a Soundcraft 600. At the moment it is completely disassembled and I'm going through the components to spot any problems.
First issue I have encountered is the master-channel fader being unsoldered. It is a Penny & Giles 3222 DMXA. As far as I can see it is the correct fader for this board, but it seems to have been taken out and tampered with. There are two sets of green, blue, yellow and red cables sticking out of the housing. There is also a black cable held in place by a screw, seems like it's the ground.. but that also is not connected to anything, just a chopped cable.
Do anyone have experience with these consoles and could help me understand which of these cables are supposed to go where on the 600?
Thanks
I'm trying to restore a Soundcraft 600. At the moment it is completely disassembled and I'm going through the components to spot any problems.
First issue I have encountered is the master-channel fader being unsoldered. It is a Penny & Giles 3222 DMXA. As far as I can see it is the correct fader for this board, but it seems to have been taken out and tampered with. There are two sets of green, blue, yellow and red cables sticking out of the housing. There is also a black cable held in place by a screw, seems like it's the ground.. but that also is not connected to anything, just a chopped cable.
Do anyone have experience with these consoles and could help me understand which of these cables are supposed to go where on the 600?
Thanks