°°° Calling all vu meters experts! °°°
Anyone knows what could be the issue in a vu meter that starts working ok (I mean, it is "bouncy" as it should when working) then after 40/50 minutes becomes a bit sticky and you have to tap on the glass to bring it back to where it should be?
I'm going nuts (it's a HOYT 597 meter). I opened it looking for dust or debris, no way. I've noticed it has a small pcb behind with some resistors and maybe a couple of diodes.
If you let the unit cooling down for an hour and switch it on again then the vu is working again... mistery!
Would love to understand where to begin troubleshooting. I swapped the connector with the other vu meter (that always works, even after hours) and it's still acting funny with all the electronics of the other channel.
Appreciate who could point me in a direction!
Anyone knows what could be the issue in a vu meter that starts working ok (I mean, it is "bouncy" as it should when working) then after 40/50 minutes becomes a bit sticky and you have to tap on the glass to bring it back to where it should be?
I'm going nuts (it's a HOYT 597 meter). I opened it looking for dust or debris, no way. I've noticed it has a small pcb behind with some resistors and maybe a couple of diodes.
If you let the unit cooling down for an hour and switch it on again then the vu is working again... mistery!
Would love to understand where to begin troubleshooting. I swapped the connector with the other vu meter (that always works, even after hours) and it's still acting funny with all the electronics of the other channel.
Appreciate who could point me in a direction!